Comparing: Fall Clean & Check vs. Heating Precision Tune-Up

Fall Clean & Check

Lasts about 30 to 45 minutes total from the time the technician arrives to the completion of the Fall Clean & Check.

 

  • Replace one throwaway filter or clean the existing filter
  • Check the thermostat operation
  • Check the indoor blower belt
  • Oil the indoor blower motor bearings
  • Check the electrical on the indoor unit
  • Clean the heat exchanger on gas furnace
  • Check the flue draft pipe
  • Check the operation of the burners on gas furnace
  • Check the operation of the pilot on gas furnace
  • Check the heat exchanger for cracks
  • Check the gas valve operation
  • Check the safety controls

Heating Precision Tune-Up

Lasts about 2 hours total from the time the technician arrives to the completion of the Heating Precision Tune-Up.

 

  • Cycle the complete system at the thermostat (including fan operation)
  • Clean and level the thermostat
  • Adjust and set the heat anticipator for the heating unit
  • Replace one throwaway filter or clean the permanent filter
  • Remove and clean the indoor blower assembly (includes motor)
  • Remove any trash or debris from indoor unit and vacuum the return air filter grill
  • Vacuum and clean the return air area under the indoor unit
  • Clean indoor heating coil (if accessible) if the system is a heat pump
  • Lubricate all moving parts on indoor unit (and outdoor unit if a heat pump)
  • Test and record all voltages and amperages on indoor heating unit (and outdoor if a heat pump)
  • Clean complete heat exchanger
  • Test heat exchanger for possible cracks
  • Test and examine all controls on indoor unit (and outdoor unit if a heat pump)
  • Tighten or adjust all belts and pulleys on indoor (and outdoor unit if a heat pump)
  • Examine and tighten all electrical connections on the heating unit (and outdoor if a heat pump)
  • Clean and apply protective coating on indoor cabinet (and outdoor if heat pump)
  • Test and record indoor air temperature
  • Test and record indoor temperature rise in heating mode
  • Test all start and run capacitors
  • Inspect all duct connections (if accessible)
  • Test the flue draft pipe for proper operation
  • Test all safety controls on heating unit

The Difficult We Will Do Immediately.  The Impossible Will Take A Little Longer.

Heating Season Tune-Up Web Specials

 

Furnace Clean & Inspect
Reg $99.00 (each unit)
Now $79.00 (each unit)*+
 
Boiler Clean & Inspect
Reg $130.00 (each unit)
Now $110.00 (each unit)*+
 
Humidifier
Clean & Inspect
Reg $46.00 (each unit)
Now $39.00 (each unit)*+
 
Water Heater Burner Clean & Check
Reg $65.00 (each unit)
Now $61.00 (each unit)*+
 
 
Ask about our 5-2-1 Compressor Saver to extend the life of your A/C compressor
 
Offer expires 8/31/2016
* Not valid with any other offer
* Repairs Additional
+ Indoor Coil Cleaning Extra
847-540-6744
Air Flow Diagnostics for Hot Rooms/Cold Rooms
Ask for details
847-540-6744

Who We Are

Climate Makers, Inc. is an HVAC/HVACR (heating, ventilation, air conditioning, and refrigeration) company based out of Lake Zurich, IL since 1978, servicing Chicago North and Northwest Suburbs.  Service on all brands.  All work guaranteed.

(847) 540-6744